U0153 serious

Lost Communication With Side Restraints Control Module Right

The U0153 code means the vehicle's onboard diagnostic system has detected: Lost Communication With Side Restraints Control Module Right. This is a serious severity code.

My Garage →
Keep driving?
Yes, but fix soon
DIY difficulty
moderate
Estimated cost
$50 - $600 (fuses, grounds, or wiring most often; module replacement only after the circuit tests good)
LAUNCH CRP123X Full System Scanner
Diagnose CAN Bus Issues
LAUNCH CRP123X Full System Scanner

Network codes mean modules are not communicating. You need a scanner that reads all systems to find the problem.

Check Price on Amazon

Affiliate links — we earn a commission at no extra cost to you.

Common Symptoms

  • Check Engine or related warning light on
  • The Side Restraints Control Module Right's functions may be degraded or offline
  • Often stored alongside other U-codes when a whole bus segment drops
  • Symptoms can be intermittent - connector and wiring faults come and go with heat and vibration

Probable Causes (Ranked by Likelihood)

  • The Side Restraints Control Module Right has lost power or ground (check its fuses first) High
  • CAN bus wiring damage - chafed harness, corroded connector, water intrusion High
  • Failed Side Restraints Control Module Right no longer transmitting Moderate
  • Another faulted module loading down the bus Low

Frequently Asked Questions

What does U0153 mean?

U0153 means other modules stopped receiving messages from the Side Restraints Control Module Right on the vehicle network. It is a communication fault - the module may be fine but unreachable.

Can I keep driving with U0153?

Cautiously and briefly - a communication fault involving a safety-related module (Side Restraints Control Module Right) can degrade braking, stability, or restraint functions without much warning. Diagnose promptly.

Should I replace the module for U0153?

Not first. Most communication codes are power, ground, fuse, or wiring problems. Replace the module only after those test good - modules are expensive and often require programming.

Mechanics Guide Step-by-step diagnosis

Step-by-Step Diagnostic Procedure

  1. Scan ALL modules - the pattern of which modules report lost communication localizes the break.

  2. Check the fuses and grounds feeding the Side Restraints Control Module Right before suspecting the module itself.

  3. If many modules are unreachable, test the CAN bus: about 60 ohms across CAN High/Low (two 120-ohm terminators) with the battery disconnected.

  4. Wiggle-test connectors along the affected harness while watching for the module to drop on and off.

  5. Only after power, ground, and bus test good should the Side Restraints Control Module Right be suspected.

Sources 1

This page is built from documented references. Verify against your own service info before repair work.

  • SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)

Commonly Affected Vehicles

  • All OBD-II vehicles - network (U) codes are standardized across makes

Related Codes

Explore More

Was this helpful?

Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.