Pressure Control Solenoid D
The P2715 code means the vehicle's onboard diagnostic system has detected: Pressure Control Solenoid D. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- Advanced
- Estimated cost
- $250 - $800 (solenoid replacement); $1,500 - $3,500 (valve body/rebuild)
Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.
Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light and/or transmission warning light on
- Harsh shifting or shift flares
- Transmission slipping during gear changes
- Vehicle may enter limp mode (stuck in one gear)
- Delayed gear engagement
Probable Causes (Ranked by Likelihood)
- Failed pressure control solenoid D High
- Contaminated transmission fluid clogging solenoid High
- Wiring fault in solenoid D circuit Medium
- Valve body wear affecting solenoid performance Medium
- TCM/PCM driver circuit failure Low
Frequently Asked Questions
What does P2715 mean?
P2715 indicates a problem with pressure control solenoid D in the transmission. The solenoid has a general malfunction.
Can I drive with P2715?
You can drive short distances carefully. Avoid hard acceleration and have the transmission inspected soon.
How much does it cost to fix P2715?
Solenoid replacement typically costs $250-$800 depending on accessibility. If the valve body is damaged, costs increase to $1,500-$3,500.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Scan for codes and confirm P2715 with freeze frame data
-
Check transmission fluid level and condition - dark or burnt fluid indicates contamination
-
Measure solenoid D resistance (compare to manufacturer specification, typically 2-10 ohms)
-
Test solenoid D operation by commanding it on/off with a scan tool
-
Inspect valve body for debris and wear if solenoid tests good
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- 2010-2018 Ford F-150 6R80 6-Speed Auto
- 2012-2020 Chevrolet Silverado 6L80 6-Speed Auto
- 2011-2019 Ram 1500 8HP70 8-Speed Auto
- 2009-2017 Toyota Camry U760E 6-Speed Auto
- 2013-2021 Honda Accord 6-Speed Auto
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.