P0854 moderate

Drive Switch Input Circuit Low

The P0854 code means the vehicle's onboard diagnostic system has detected: Drive Switch Input Circuit Low. This is a moderate severity code.

My Garage →
Keep driving?
Short distances only
DIY difficulty
moderate
Estimated cost
$100 - $500 (parts and labor)
ANCEL AD310 OBD-II Scanner
Check Your Fluid First
ANCEL AD310 OBD-II Scanner

Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.

Check Price on Amazon
LAUNCH CRP123X (Reads All Systems)
Read Transmission Codes
LAUNCH CRP123X (Reads All Systems)

Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.

Check Price on Amazon

Affiliate links — we earn a commission at no extra cost to you.

Common Symptoms

  • Check Engine Light illuminated
  • TCM does not detect Drive gear selection
  • Gear indicator stuck or incorrect
  • Transmission may default to limp mode

Probable Causes (Ranked by Likelihood)

  • Short to ground in drive switch signal wire Very High
  • Faulty range sensor with low output in Drive position High
  • Corroded connector at transmission range sensor Moderate
  • PCM or TCM internal input failure Low

Frequently Asked Questions

What causes the drive switch signal to read low?

A low signal is usually caused by a short to ground in the wiring or a faulty sensor. Road debris and water splash can damage the wiring or connector at the transmission.

Is P0854 specific to the Drive gear only?

Yes, P0854 specifically relates to the Drive position input. Other gear positions have their own circuit codes.

Can I manually select a gear to avoid the issue?

If your vehicle has a manual mode or low gear selection, it may work around the Drive detection issue temporarily, but the underlying problem should be repaired.

Mechanics Guide Step-by-step diagnosis

Step-by-Step Diagnostic Procedure

  1. Measure voltage at the drive switch input with the shifter in Drive

  2. Check for a short to ground in the signal wire

  3. Clean or replace corroded connector pins

  4. Test range sensor through all positions and compare to specifications

Sources 1

This page is built from documented references. Verify against your own service info before repair work.

  • SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)

Commonly Affected Vehicles

  • 2008-2018 Nissan Rogue
  • 2010-2020 Ford Edge
  • 2007-2017 Hyundai Santa Fe
  • 2009-2019 Kia Sorento

Related Codes

Explore More

Was this helpful?

Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.