Clutch Pedal Switch A Circuit
The P0830 code means the vehicle's onboard diagnostic system has detected: Clutch Pedal Switch A Circuit. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- easy
- Estimated cost
- $20 - $150 (parts and labor)
Read and clear transmission codes. Many trans codes are caused by low or burnt fluid -- check level and color before assuming the worst.
Basic scanners only read engine codes. This reads transmission, ABS, and airbag too.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light illuminated
- Cruise control inoperative
- Engine will not start even with clutch pedal pressed
- Vehicle does not recognize clutch pedal input
Probable Causes (Ranked by Likelihood)
- Faulty clutch pedal switch Very High
- Misadjusted clutch pedal switch High
- Damaged wiring or connector at switch Moderate
- PCM input circuit failure Low
Frequently Asked Questions
What is clutch pedal switch A?
Many vehicles have two clutch pedal switches: switch A is typically used for the starter interlock (preventing starting without clutch pressed) and cruise control disable. Switch B may serve other functions.
Is the clutch pedal switch the same as the clutch position sensor?
No, a clutch pedal switch is a simple on/off switch, while a clutch position sensor provides a variable voltage signal indicating how far the pedal is depressed.
Can I replace the clutch pedal switch myself?
Yes, the clutch pedal switch is usually a simple clip-on part at the top of the clutch pedal. It can be replaced in minutes with no special tools.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Locate the clutch pedal switch at the top of the clutch pedal
-
Test the switch with a multimeter while pressing and releasing the pedal
-
Verify the switch is properly positioned and adjusted
-
Check wiring and connector between the switch and PCM
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
Commonly Affected Vehicles
- 2010-2020 Ford Mustang
- 2008-2018 Chevrolet Silverado (manual)
- 2012-2019 Jeep Wrangler
- 2007-2017 Toyota Tacoma (manual)
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.