Catalyst Temperature Sensor High (Bank 2)
The P0438 code means the vehicle's onboard diagnostic system has detected: Catalyst Temperature Sensor High (Bank 2). This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- moderate
- Estimated cost
- $80 - $400 (parts and labor)
Reads enhanced codes and shows real-time O2 sensor data. Verify the cat is actually bad before dropping $1,000+ on a replacement.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light illuminated
- Scan tool shows abnormally high Bank 2 catalyst temperature
- Possible overheating warning
- No drivability issues in most cases
Probable Causes (Ranked by Likelihood)
- Faulty Bank 2 catalyst temperature sensor reading high Very High
- Short to voltage in Bank 2 sensor signal wire High
- Open ground wire causing signal to float high Moderate
- Genuine catalyst overheating from Bank 2 misfires Moderate
Frequently Asked Questions
Can I drive with code P0438?
Drive short distances only until diagnosed. While a faulty sensor is most likely, if the Bank 2 catalyst is genuinely overheating, continued driving risks a fire or catalyst destruction.
Is P0438 the Bank 2 version of P0428?
Yes. P0428 covers Bank 1 catalyst temperature sensor high and P0438 covers Bank 2. The diagnostic process is identical on the opposite bank.
How do I verify if the catalyst is actually overheating?
Use an infrared thermometer on the Bank 2 exhaust pipe near the converter. If it matches the abnormally high scan tool reading, the overheating is real and likely caused by misfires or a rich condition.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Compare scan tool Bank 2 catalyst temperature to an infrared thermometer measurement
-
Check if the reading is plausible -- readings above 1800 degrees F likely indicate a sensor fault
-
Verify Bank 2 sensor ground wire continuity
-
Check signal wire for short to voltage
-
If readings appear accurate, check for Bank 2 misfires or rich fuel condition
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- 2005-2017 Toyota Tundra V8
- 2006-2018 Lexus IS 350
- 2004-2016 Nissan Titan
- 2003-2015 Subaru Outback H6
- 2007-2019 Toyota Sequoia
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.