Left Side Restraints Sensor 3
The B0093 code means the vehicle's onboard diagnostic system has detected: Left Side Restraints Sensor 3. This is a serious severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- hard
- Estimated cost
- $80 - $700 (connector or wiring commonly; sensor mat or seat-sensor replacement at the high end)
Basic scanners skip body codes entirely. BlueDriver reads airbag, HVAC, lighting, and BCM codes through your phone.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Airbag (SRS) warning light on
- Occupant detection or belt-status behavior wrong (e.g. passenger airbag off with an adult seated)
- No drivability symptom - this is purely a safety-system fault
Probable Causes (Ranked by Likelihood)
- Faulty or disturbed sensor (this circuit's sensor is often under or inside a seat and gets damaged by movement, spills, or objects beneath the seat) High
- Damaged wiring or corroded connector in the sensor circuit High
- SRS control module input fault Low
Frequently Asked Questions
What does B0093 mean?
B0093 is a generic (ISO/SAE-standardized) restraints code: a fault in the Left Side Restraints Sensor 3 circuit. The SRS module monitors every restraint circuit continuously and sets this when that circuit fails its checks.
Can I keep driving with B0093?
An SRS fault usually means part of the airbag or seatbelt system is DISABLED until repaired - the airbag warning light stays on and that restraint may not deploy in a crash. Never probe deployment-loop (squib) circuits with a test light or ohmmeter; accidental deployment causes serious injury. SRS diagnosis belongs at a qualified shop.
Will the airbag still work with B0093 stored?
Assume no for the affected restraint. With most SRS faults, the module disables the affected circuit (sometimes the whole system) until it is repaired and the code cleared. That is why the warning light stays on.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Read the code and subfault detail with an SRS-capable scan tool.
-
Check for obvious causes first: objects wedged under the seat, unplugged under-seat connectors after cleaning or repairs.
-
Inspect the circuit's wiring per the OEM procedure with the SRS disabled.
-
Follow the OEM calibration/relearn procedure after any occupant-sensor repair - many require a zero-point reset.
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
Commonly Affected Vehicles
- All OBD-II vehicles - generic (ISO/SAE) restraints code standardized across makes
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.