Crankshaft Position Signal Output Circuit High
The POWERSTROKE-P2619 (Power Stroke) diesel fault code means: Crankshaft Position Signal Output Circuit High. This is a serious severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- advanced
- Estimated cost
- $100 - $500 (wiring or connector repair most often)
Down with a Power Stroke fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- Hard start, no-start, or dying while driving
- Tachometer dropout can accompany the fault
Probable Causes (Ranked by Likelihood)
- Open/short in the position-signal output wiring between PCM and the receiving module High
- Connector corrosion (salt-belt trucks especially) High
- Receiving module input fault Moderate
- PCM output driver fault Low
Frequently Asked Questions
What is P2619 on a 6.0L Power Stroke?
P2619 on a 6.0L Power Stroke (2003-2007) indicates: FICM 48V Power Supply. This is a known diagnostic trouble code on this engine family and typically points to the causes listed above.
Can I drive with P2619 on my Power Stroke?
Only drive short distances to get to a repair facility. Continued operation may cause further damage.
How much does it cost to fix P2619?
Repair cost is typically $300-$900 depending on the underlying cause and whether you DIY or use a shop. Diagnostic time alone runs $100-$180 at most independent diesel shops.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
Understand the circuit first: The CKP output signal circuit reads high - the re-transmitted crank signal, not the crank sensor itself.
Check the output signal wiring end to end per the Ford pinpoint test.
Inspect connectors for corrosion and spread terminals.
Do not replace the cam/crank SENSOR for this code - the sensors have their own separate codes.
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines P2619 as a generic OBD-II code)
P2619 on Other Platforms
The same code ID appears across other engines, vehicles, and equipment. Diagnostic flow varies by platform — see the matching breakdown:
Commonly Affected Vehicles
- 2003-2007 Ford F-250 Super Duty 6.0L Power Stroke
- 2003-2007 Ford F-350 Super Duty 6.0L Power Stroke
- 2003-2007 Ford F-450/F-550 Super Duty 6.0L Power Stroke
- 2003-2010 Ford E-350/E-450 6.0L Power Stroke
- 2003-2005 Ford Excursion 6.0L Power Stroke
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the truck — your tech, or the person asking what the fault means.