Fan 1 Control Circuit
The MAXXFORCE-P0480 (MaxxForce) diesel fault code means: Fan 1 Control Circuit. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- intermediate
- Estimated cost
- $400-$1,200
Down with a MaxxForce fault on the road?
Get connected with a verified mobile diesel mechanic near you. Verified diesel & reefer techs, launching on the freight corridor.
Find a mobile mechanic →A $30 car code reader can't do diesel. The HD7000 reads full-system codes and does parked DPF regen, idle/speed-limit, and service resets from the cab — on everything from a 6.7 Cummins/Power Stroke/Duramax pickup to Class-8 trucks (Detroit, Paccar, CAT, Volvo, Mack, International).
Full-system 6/9/16-pin diesel scan tool for Cummins, Paccar, CAT, Detroit and more — plug-and-play, no subscription. A cheaper way to read heavy-duty codes a basic OBD2 scanner skips entirely.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Overheating under load
- CEL
Probable Causes (Ranked by Likelihood)
- Failed viscous fan clutch Likely
- Open fan solenoid wiring Possible
Frequently Asked Questions
What is P0480 on a MaxxForce DT (7.6L)?
P0480 on a MaxxForce DT (7.6L) (2007-2015) indicates: Fan 1 Control Circuit. This is a known fault code on the MaxxForce engine family and typically points to the causes listed above.
Can I drive with P0480 on my MaxxForce?
Only drive short distances to reach a repair facility. Continued operation may cause further damage or progressive derate.
How much does it cost to fix MaxxForce P0480?
Repair cost is typically $400-$1,200 depending on the underlying cause and shop rate. Many MaxxForce faults (especially EGR cooler, head bolt, and VGT repairs) are major expenses that drove fleet owners to repower with Cummins or retire these trucks early.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
Verify fan engages when commanded.
Replace fan clutch if it freewheels hot.
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines P0480 as a generic OBD-II code)
P0480 on Other Platforms
The same code ID appears across other engines, vehicles, and equipment. Diagnostic flow varies by platform — see the matching breakdown:
Commonly Affected Vehicles
- International 4300 DuraStar MaxxForce DT
- International 4400 DuraStar MaxxForce DT
- International 7300/7400/7500 WorkStar MaxxForce DT
- IC Bus CE-Series MaxxForce DT
- IC Bus RE-Series MaxxForce DT
Explore More
Was this helpful?
Send this to whoever is fixing the truck — your tech, or the person asking what the fault means.