Aftertreatment SCR Inlet NOx Sensor - Voltage Below Normal

Cummins fault code 2617 indicates: Aftertreatment SCR Inlet NOx Sensor - Voltage Below Normal. It is a moderate-severity fault in the aftertreatment or emissions system.

Short-term, yes, but the engine will enter derate (typically starting at 55 mph and progressing to 5 mph for emissions faults). Drive directly to a repair facility. Do not defer this fault more than a few operating hours.

Repair cost is approximately $800-$2,500 including parts, labor, and any dealer programming required. DIY repairs (sensor replacement) fall at the low end; pump, aftertreatment, or ECM work falls at the high end and usually requires INSITE diagnostic software.

California's heavy-duty OBD regulation requires the system to flag a NOx-converting catalyst when its conversion capability drops enough to push NOx emissions more than 0.4 g/bhp-hr above the applicable standard (Title 13 CCR 1971.1, section (e)(6.2.1)) — so on a 0.2 g/bhp-hr engine the trip point is around 0.6. Catalysts in series may be monitored individually or as a group, which is why a code can point at the aftertreatment as a whole rather than at one brick. This threshold comes from the heavy-duty OBD regulation, which covers 2010 and later heavy-duty engines. If your engine is in a pickup at or under 14,000 lb GVWR it is certified under the separate medium-duty rule instead, so treat this as the design intent rather than your engine's exact limit.