"B" Rocker Arm Actuator Control Circuit High Bank 2
The P2664 code means the vehicle's onboard diagnostic system has detected: "B" Rocker Arm Actuator Control Circuit High Bank 2. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- moderate
- Estimated cost
- $100 - $600 (wiring or connector at the low end; actuator/valve replacement at the high end)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- Drivability may be normal - many circuit faults show no symptom the driver notices
- The affected system may fall back to a default strategy, costing power or economy
- Related values implausible or frozen on a scan tool
Probable Causes (Ranked by Likelihood)
- Fault in the "B" Rocker Arm Actuator Control Circuit High circuit: a fault in this circuit High
- Damaged wiring, a chafed harness, or a corroded connector at the "B" Rocker Arm Actuator Control Circuit High High
- Failed "B" Rocker Arm Actuator Control Circuit High Moderate
- Control module input/driver fault (rule this out last - it is the least common) Low
Frequently Asked Questions
What does P2664 mean?
P2664 is a generic OBD-II code defined by SAE J2012 as ""B" Rocker Arm Actuator Control Circuit High Bank 2". It means the control module detected a fault in this circuit
Can I keep driving with P2664?
Yes for normal use, but get it diagnosed - the system is running on a fallback strategy and a small wiring fault left alone tends to become a bigger one.
Does P2664 mean the same thing on every car?
Yes. P2664 is in the generic (SAE J2012) range, so the definition is standardized across manufacturers. The specific component location and repair procedure still vary by vehicle - check your service information.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Read the code and freeze-frame data, then watch the "B" Rocker Arm Actuator Control Circuit High live on a scan tool.
-
Inspect the connector and harness at the "B" Rocker Arm Actuator Control Circuit High before replacing anything - wiring and corrosion cause most of these.
-
Back-probe the circuit and compare signal, ground, and reference voltage against the service-manual values.
-
Wiggle-test the harness while watching the live value if the fault is intermittent.
-
Clear the code and confirm with a road test that covers the conditions in the freeze frame.
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
Commonly Affected Vehicles
- All OBD-II vehicles - this is a generic (SAE J2012) code with the same meaning across makes
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.