Exhaust Gas Temperature Sensor Circuit Bank 2 Sensor 3
The P2466 code means the vehicle's onboard diagnostic system has detected: Exhaust Gas Temperature Sensor Circuit Bank 2 Sensor 3. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- moderate
- Estimated cost
- $80 - $450 (wiring or connector at the low end; sensor replacement at the high end - diagnose before buying parts)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- Drivability may be normal - many circuit faults show no symptom the driver notices
- The affected system may fall back to a default strategy, costing power or economy
- Related values implausible or frozen on a scan tool
Probable Causes (Ranked by Likelihood)
- Fault in the Exhaust Gas Temperature Sensor Circuit circuit: a fault in this circuit High
- Damaged wiring, a chafed harness, or a corroded connector at the Exhaust Gas Temperature Sensor Circuit High
- Failed Exhaust Gas Temperature Sensor Circuit Moderate
- Control module input/driver fault (rule this out last - it is the least common) Low
Frequently Asked Questions
What does P2466 mean?
P2466 is a generic OBD-II code defined by SAE J2012 as "Exhaust Gas Temperature Sensor Circuit Bank 2 Sensor 3". It means the control module detected a fault in this circuit
Can I keep driving with P2466?
Yes for normal use, but get it diagnosed - the system is running on a fallback strategy and a small wiring fault left alone tends to become a bigger one.
Does P2466 mean the same thing on every car?
Yes. P2466 is in the generic (SAE J2012) range, so the definition is standardized across manufacturers. The specific component location and repair procedure still vary by vehicle - check your service information.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Read the code and freeze-frame data, then watch the Exhaust Gas Temperature Sensor Circuit live on a scan tool.
-
Inspect the connector and harness at the Exhaust Gas Temperature Sensor Circuit before replacing anything - wiring and corrosion cause most of these.
-
Back-probe the circuit and compare signal, ground, and reference voltage against the service-manual values.
-
Wiggle-test the harness while watching the live value if the fault is intermittent.
-
Clear the code and confirm with a road test that covers the conditions in the freeze frame.
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
P2466 on Diesel, EV & Equipment
The same code ID appears across other engines and platforms. The diagnostic flow varies by manufacturer — these are the platform-specific breakdowns:
Commonly Affected Vehicles
- All OBD-II vehicles - this is a generic (SAE J2012) code with the same meaning across makes
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.