System Too Lean at Idle -- Bank 2
The P2189 code means the vehicle's onboard diagnostic system has detected: System Too Lean at Idle -- Bank 2. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- moderate
- Estimated cost
- $80 - $400 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Rough idle
- Engine misfires at idle
- Idle speed fluctuation
- Slight hesitation from stop
- Check engine light on
Probable Causes (Ranked by Likelihood)
- Vacuum leak on bank 2 side of intake manifold Very High
- Clogged fuel injectors on bank 2 High
- Intake manifold gasket leak on bank 2 side Moderate
- Cracked vacuum hose routed to bank 2 side Moderate
- Faulty bank 2 oxygen sensor reading rich (causing lean compensation) Low
Common Fixes by Vehicle
What techs usually find when diagnosing P2189 on specific vehicles — tap your vehicle for the fix and the exact part:
2006-2018 V6/V8 (GM, Ford, VW) moderate DIY
System too lean at idle on bank 2 points to unmetered air or weak fuel delivery. Smoke-test for vacuum leaks at the intake gaskets, PCV, and brake booster hose first — that is the most common cause. Clean the MAF sensor. Check fuel trims: high positive trims at idle that normalize at cruise confirm a vacuum leak.
Labor: 1-3 hoursFrequently Asked Questions
Can I drive with code P2189?
Yes, you can drive, but expect rough idle and possibly slight misfires. The lean condition is only at idle, which limits its severity. However, persistent lean conditions can damage the catalytic converter on bank 2 over time.
Why is only bank 2 lean and not bank 1?
When only bank 2 is lean at idle, the cause is isolated to that side of the engine. This is most commonly a vacuum leak at the bank 2 intake manifold gasket, a cracked vacuum hose on that side, or clogged injectors feeding bank 2 cylinders.
Which cylinders are on bank 2?
Bank 2 is the side of the engine that does not contain cylinder 1. On most V6 engines, bank 2 is cylinders 2-4-6 or 4-5-6 depending on the manufacturer. Check your vehicle's service manual for the specific cylinder bank layout.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Check bank 2 fuel trims at idle -- long-term fuel trim above +15% confirms lean at idle
-
Compare bank 1 and bank 2 fuel trims -- if only bank 2 is lean, the issue is isolated to that side
-
Perform smoke test focusing on bank 2 intake runners and gasket area
-
Test fuel injector flow balance on bank 2 cylinders
-
Inspect all vacuum hoses and connections on the bank 2 side of the engine
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- 2007-2017 Toyota Camry V6
- 2008-2016 Nissan Maxima
- 2009-2018 Honda Accord V6
- 2010-2019 Ford Explorer V6
- 2006-2015 Chevrolet Impala V6
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.