Throttle/Pedal Position Sensor "B" Maximum Stop Performance
The P2164 code means the vehicle's onboard diagnostic system has detected: Throttle/Pedal Position Sensor "B" Maximum Stop Performance. This is a moderate severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- moderate
- Estimated cost
- $80 - $400 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- A scan tool shows Throttle/Pedal Position Sensor "B" Maximum Stop Performance as the stored fault
- Drivability may be normal - many faults in this circuit show no symptom the driver notices
- The system may fall back to a default strategy until the fault is cleared
Probable Causes (Ranked by Likelihood)
- Wiring or connector fault at the throttle/pedal position sensor B - chafed harness, corroded pins, or a loose ground High
- Failed throttle/pedal position sensor B Medium
- A supply or reference voltage problem shared with other circuits, which usually sets companion codes too Medium
- Control module fault - rare, and only after the wiring and the component have both been ruled out Low
Frequently Asked Questions
What does P2164 mean?
Throttle/Pedal Position Sensor "B" Maximum Stop Performance. That definition comes from SAE J2012, the standard that assigns generic OBD-II trouble code meanings.
Is P2164 the same on every vehicle?
The definition is standardized, but the exact test that sets it, the specified voltages and the physical location of the component vary by make and model. Check your vehicle's service information for those.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Read ALL stored codes first. Faults in this area often set several codes at once, and the cheapest cause is usually shared wiring rather than the part.
-
Inspect the connector and harness at the throttle/pedal position sensor B for corrosion, backed-out pins, and chafing before testing anything electrically.
-
Back-probe the circuit with the connector attached and compare the reading against the manufacturer's specification for your vehicle - generic values do not apply across makes.
-
Check power, ground and reference voltage feeding the circuit before condemning the component.
-
Replace the component only after the wiring tests good. Confirm the repair by clearing the code and verifying it does not return under the conditions that set it.
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- 2010-2020 Toyota Camry 2.5L
- 2008-2018 Honda Accord 2.4L
- 2008-2018 Ford F-150 5.0L
- 2010-2019 Chevrolet Silverado 5.3L
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.