Throttle/Pedal Position Sensor/Switch A/B Voltage Correlation
The P2136 code means the vehicle's onboard diagnostic system has detected: Throttle/Pedal Position Sensor/Switch A/B Voltage Correlation. This is a critical severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- moderate
- Estimated cost
- $100 - $600 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Reduced engine power
- Erratic throttle response
- Engine may hesitate or surge
- Limp mode warning
- Check engine light on
Probable Causes (Ranked by Likelihood)
- Worn throttle position sensor with mismatched A/B readings Very High
- Carbon buildup affecting TPS readings High
- Corroded throttle body connector Moderate
- Wiring issue causing one TPS track to read differently Moderate
- Electronic throttle body mechanical wear Low
Frequently Asked Questions
Can I drive with code P2136?
Only short distances. The PCM has detected that the two throttle position signals do not agree, which compromises its ability to accurately control the throttle. Reduced power mode is likely active.
What is A/B voltage correlation?
The electronic throttle body has two position sensor tracks (A and B) that should maintain a specific mathematical relationship. If sensor A reads a certain voltage, sensor B should read a predictable corresponding voltage. When this correlation breaks down, the PCM cannot trust the throttle position.
Is this the same as P2135?
They are closely related. P2135 specifically indicates the A/B correlation is out of range, while P2136 may indicate a broader correlation issue. Both point to the same general problem -- the two TPS tracks on the throttle body do not agree.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Compare TPS A and TPS B voltages on scan tool -- they should maintain a consistent ratio throughout throttle range
-
Graph both TPS signals during a slow throttle sweep -- look for divergence at any point
-
Clean electronic throttle body to eliminate carbon as a variable
-
Inspect throttle body connector for corrosion affecting one circuit more than the other
-
Replace throttle body if A/B correlation error persists after cleaning and connector inspection
Sources 1
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
Commonly Affected Vehicles
- 2007-2017 Nissan Altima
- 2008-2016 Toyota Camry
- 2009-2018 Honda Civic
- 2010-2019 Chevrolet Equinox
- 2006-2015 Ford Fusion
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.