Evaporator Temperature Sensor Circuit High
The P0538 code means the vehicle's onboard diagnostic system has detected: Evaporator Temperature Sensor Circuit High. This is a low severity code.
- Keep driving?
- Yes, but fix soon
- DIY difficulty
- hard
- Estimated cost
- $100 - $500 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- Evaporator may freeze up
- AC runs constantly without cycling
- Ice buildup on evaporator
Probable Causes (Ranked by Likelihood)
- Open circuit in evaporator temperature sensor wiring Very High
- Failed sensor with open internal circuit High
- Disconnected evaporator temperature sensor connector Moderate
- Corroded pins causing high resistance in sensor circuit Moderate
Frequently Asked Questions
Why does the evaporator freeze with P0538?
When the sensor reads high (falsely indicating a warm evaporator), the system never cycles the compressor off to prevent freezing. The compressor runs continuously, dropping the evaporator temperature below freezing and causing ice buildup.
How do I know if my evaporator is frozen?
A frozen evaporator blocks airflow through the vents. You may notice reduced or no airflow from the vents even with the blower on high, followed by a gush of water when the ice melts after shutting off the AC.
What does circuit high mean for P0538?
Circuit high means the sensor signal voltage is above the expected maximum, making the system read an extremely warm temperature. This is typically caused by an open circuit (broken wire or disconnected sensor) where the pull-up voltage reads through.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Read evaporator temperature sensor value; an extremely warm reading when AC is running cold confirms circuit high
-
Check sensor connector for disconnection or corrosion
-
Measure sensor resistance; an open reading (infinite ohms) confirms sensor failure
-
Inspect wiring for breaks, especially where it passes through the firewall or HVAC housing
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- 2010-2020 Ford Explorer
- 2012-2019 Chevrolet Silverado
- 2008-2018 Toyota 4Runner
- 2011-2020 Honda Pilot
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.