Misfire Detected - Fueling Disabled
The P0363 code means the vehicle's onboard diagnostic system has detected: Misfire Detected - Fueling Disabled. This is a serious severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- moderate
- Estimated cost
- $50 - $700 (plugs/coils commonly; injector or mechanical causes cost more)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on, often flashing under load
- Rough running, shaking, or hesitation
- Reduced power and fuel economy
Probable Causes (Ranked by Likelihood)
- Ignition fault - worn plug, failed coil, or damaged boot High
- Fuel delivery fault - clogged or failed injector High
- Vacuum leak or low compression on the affected cylinder Moderate
Frequently Asked Questions
What does P0363 mean?
P0363 is a generic OBD-II code defined by SAE J2012 as "Misfire Detected - Fueling Disabled". It means the control module detected a fault in this circuit
Can I keep driving with P0363?
Short trips only. This fault can worsen or put the system into a protective mode without much warning, so have it diagnosed promptly.
Does P0363 mean the same thing on every car?
Yes. P0363 is in the generic (SAE J2012) range, so the definition is standardized across manufacturers. The specific component location and repair procedure still vary by vehicle - check your service information.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
A FLASHING check engine light means an active misfire dumping raw fuel into the catalyst - stop driving and repair.
-
Read misfire counters per cylinder on a scan tool.
-
Swap the coil and plug with a neighboring cylinder; if the misfire follows, you found it.
-
If ignition and fuel test good, check compression on the affected cylinder.
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- All OBD-II vehicles - this is a generic (SAE J2012) code with the same meaning across makes
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.