Ignition Coil Primary/Secondary Circuit Malfunction
The P0350 code means the vehicle's onboard diagnostic system has detected: Ignition Coil Primary/Secondary Circuit Malfunction. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- moderate
- Estimated cost
- $100 - $400 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Engine misfires on one or more cylinders
- Rough idle and vibration
- Check Engine Light illuminated
- Reduced power and acceleration
- Poor fuel economy
Probable Causes (Ranked by Likelihood)
- Faulty ignition coil Very High
- Damaged coil connector or wiring High
- Worn or fouled spark plug causing coil overload High
- PCM ignition coil driver circuit failure Moderate
- Poor engine ground affecting coil circuit Low
Frequently Asked Questions
Can I drive with code P0350?
You can drive short distances. The engine will misfire and run rough. Prolonged driving with a misfiring cylinder can damage the catalytic converter.
Should I replace all ignition coils at once?
It is not strictly necessary, but if one coil has failed and the others are the same age with high mileage, replacing them as a set can prevent future failures and save on repeat labor.
Can a bad spark plug kill an ignition coil?
Yes. A worn or gapped-too-wide spark plug forces the coil to produce higher voltage, which can overheat and burn out the coil prematurely. Always replace spark plugs at recommended intervals.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Check for companion misfire codes (P0301-P0312) to identify the affected cylinder
-
Measure ignition coil primary resistance -- should be 0.4-2.0 ohms; secondary resistance should be 6,000-15,000 ohms
-
Swap the suspect coil with a known-good coil from another cylinder -- if the misfire follows, the coil is bad
-
Inspect the coil connector for corrosion, melted plastic, or damaged pins
-
Check the spark plug condition -- a worn or fouled plug can cause premature coil failure
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- 2007-2017 Toyota Camry
- 2008-2018 Honda Accord
- 2005-2015 Ford F-150
- 2010-2020 Chevrolet Silverado
- 2009-2019 Nissan Altima
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.