Cylinder 10 Contribution/Balance Fault
The P0290 code means the vehicle's onboard diagnostic system has detected: Cylinder 10 Contribution/Balance Fault. This is a moderate severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- hard
- Estimated cost
- $150 - $700 (parts and labor)
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Engine misfire on cylinder 10
- Rough idle and vibration
- Check Engine Light illuminated
- Uneven power delivery
- Engine shakes especially at idle
Probable Causes (Ranked by Likelihood)
- Faulty cylinder 10 fuel injector (incorrect fuel delivery) Very High
- Low compression in cylinder 10 High
- Leaking or clogged injector on cylinder 10 High
- Vacuum leak at cylinder 10 intake runner Moderate
- Worn camshaft lobe affecting cylinder 10 valves Low
Frequently Asked Questions
Can I drive with code P0272?
You can drive short distances with light loads. Cylinder 10 is producing less power than normal, and the engine will run rough. Avoid towing until repaired.
Is P0272 always a serious problem?
Not always. It could be as simple as a clogged injector that needs cleaning. However, low compression or a worn camshaft lobe would indicate a more serious mechanical issue requiring significant repair.
Can fuel quality cause a contribution fault?
Contaminated or low-quality fuel can cause injector clogging and uneven fuel delivery, which may trigger contribution codes. Using quality fuel and periodic injector cleaning can help prevent this.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Perform a cylinder contribution test using a scan tool to compare each cylinder's output
-
Run a compression test -- cylinder 10 should be within 10% of the highest cylinder
-
Swap cylinder 10 injector with another cylinder to determine if the injector is the cause
-
Check for vacuum leaks at cylinder 10 intake port using a smoke machine
-
If compression is low, perform a leak-down test to identify the failure point
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- 2010-2020 Ford F-350 (6.8L V10)
- 2008-2018 Dodge Ram 3500 (8.0L V10)
- 2012-2019 Lamborghini Gallardo (5.2L V10)
- 2011-2020 Audi R8 (5.2L V10)
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.