Fuel Temperature Too High
The P0168 code means the vehicle's onboard diagnostic system has detected: Fuel Temperature Too High. This is a serious severity code.
- Keep driving?
- Short distances only
- DIY difficulty
- hard
- Estimated cost
- Varies - the code reports a limit was exceeded; cost follows whatever caused it. Diagnose the cause, not the symptom.
Best-selling code reader on Amazon. Reads and clears check engine codes on any 1996+ vehicle. Under $30.
Essential for diagnosing sensor codes, checking voltage, and testing circuits. Under $15 and pays for itself on the first job.
Affiliate links — we earn a commission at no extra cost to you.
Common Symptoms
- Check Engine Light on
- Reduced power as the system protects itself
- Symptoms worst under load, on grades, or in heat
- May clear on its own once conditions return to normal
Probable Causes (Ranked by Likelihood)
- A real over/under-limit condition in the Fuel Temperature Too - the code reports the measurement, not the cause High
- Cooling, flow, or supply problem in the related system High
- Sensor over- or under-reporting (verify the reading is real before repairs) Moderate
Frequently Asked Questions
What does P0168 mean?
P0168 is a generic OBD-II code defined by SAE J2012 as "Fuel Temperature Too High". It means the control module detected the signal reading above its valid range - typically a short to voltage or an open reference
Can I keep driving with P0168?
Short trips only. This fault can worsen or put the system into a protective mode without much warning, so have it diagnosed promptly.
Does P0168 mean the same thing on every car?
Yes. P0168 is in the generic (SAE J2012) range, so the definition is standardized across manufacturers. The specific component location and repair procedure still vary by vehicle - check your service information.
Mechanics Guide Step-by-step diagnosis
Step-by-Step Diagnostic Procedure
-
Read the freeze-frame value the module recorded - confirm the limit was genuinely exceeded, not just misreported.
-
Check the supporting system (cooling, flow, pressure, supply) that should have kept Fuel Temperature Too in range.
-
Verify the sensor against a known-good reference before replacing expensive components.
-
Road-test while logging the value to confirm the repair.
Sources 2
This page is built from documented references. Verify against your own service info before repair work.
- SAE J2012Diagnostic Trouble Code Definitions (defines the generic OBD-II code ranges)
- Cross-checked against the SAE J2012:2002 DTC table (2026-08-27)archived scan of the SAE standard — readable copy, not SAE’s current edition
Commonly Affected Vehicles
- All OBD-II vehicles - this is a generic (SAE J2012) code with the same meaning across makes
Related Codes
Explore More
Was this helpful?
Send this to whoever is fixing the car — your mechanic, or the person asking what the light means.