O2 Sensor Circuit (Bank 1, Sensor 3)

Only certain vehicle configurations with two catalytic converters in series on one bank use a Sensor 3 position. Most cars only have Sensor 1 (upstream) and Sensor 2 (downstream).

The OBD II regulation requires four separate detections for an oxygen sensor (Title 13 CCR 1968.2, section (e)(7.2)): deterioration in voltage, response rate or amplitude that would push emissions past 1.5 times the FTP standards; loss of circuit continuity; out-of-range values; and the case where the sensor has degraded enough that the fuel system stops using it and falls back to open loop. A sensor can therefore set a code while still producing a signal that looks plausible on a scan tool. This is the threshold the monitor is designed around, not a description of your specific fault — the regulation says what the system must detect, not how to find it on your vehicle.