Control Module VSS Output A Malfunction
What does P0608 mean?
The P0608 code means the vehicle's onboard diagnostic system has detected: Control Module VSS Output A Malfunction. This is a moderate severity code.
Common Symptoms
- Check Engine Light illuminated
- Speedometer may not work
- Cruise control inoperative
- Transmission may not shift properly
Probable Causes (Ranked by Likelihood)
- ECM vehicle speed signal output circuit fault Very High
- Damaged wiring from ECM to speedometer/TCM High
- Failed instrument cluster speed input Moderate
- ECM internal VSS output driver failure Low
Step-by-Step Diagnostic Procedure
-
Check vehicle speed signal at the ECM output pin
-
Verify speedometer operation and compare to GPS speed
-
Check wiring from ECM VSS output to receiving modules
-
Inspect ECM connector pins for damage
-
Replace ECM if internal VSS output driver has failed
Frequently Asked Questions
Can I drive with code P0608?
Drive short distances only. Internal control module errors can cause unpredictable engine behavior.
Does P0608 mean I need a new ECM?
Not always. Some internal module errors can be resolved by reprogramming or reflashing the ECM with factory software. However, hardware failures (RAM, ROM, processor) typically require ECM replacement.
How much does an ECM replacement cost?
ECM replacement typically costs $300-$1500 including the part and programming. The ECM must be programmed with the correct calibration and vehicle options for your specific VIN.